Honsberg LABO-F012-S100KPH0H in GERMANY
Get the best sales prices in GERMANY for Honsberg LABO-F012-S100KPH0H from Impexron GmbH.
If you need LABO-F012-S100KPH0H to recover your broken equipment or machines or for new applications, you are on the right website.
A member of our experts will get the cheapest sales prices for products of Honsberg - LABO-F012-S100KPH0H Flow switch in Germany.
By buying products of Honsberg and using our service you get high quality products with cheap prices.
Get the best spare parts prices from a single source, don't waste time seeking for different suppliers when you can just go with one.
Our company is not a representative of Honsberg, but we are selling their products at good prices.
Grab the best offer for Honsberg - LABO-F012-S100KPH0H Flow switch in Germany.We are a stable and reliable company which has earned the trust of many customers, as can be seen from our client list.
You may send us an inquiry by e-mail or by using our online contact form.
Characteristics :
The sensors of the LABO-F012 family are used for monitoring
non-viscous fluids (for oil or gases on request). They come
complete with electronics, and are supplied installed inside a
compact sensor housing of 12 mm diameter and with M12x1 round
plug outlet. The 16-bit processor carries out temperature
compensation and linearisation of the calorimetric signal
(measurement of the heat removal at the sensor tip by the flowing
medium; for this see also the general description for calorimetry).
The electronics of the LABO-F012-S are a flexibly configurable limit
switch.
The switching value can be set by the user via teaching (see
Handling and Operation). All other values have been preset at the
factory, but can be modified by the user with the aid of the
optionally available ECI-1 interface and a PC.
The adjustable parameters are:
● Switching value
● Hysteresis
● Minimum/maximum monitoring
● Switching delay
● Switchback delay
● Power-On delay
● Teach-offset
Technical data
Sensor : Calorimetric measurement principle
Process connection : push-in sensor Ø12 mm
Switching range water : 2..150 cm/s or 3..300 cm/s oil or gases available on request
Measurement accuracy : dependent on the installation location and flow conditions typically ±10 % of full scale value or 2 cm/s, of full scale value measured in the T-piece ±5 %
Repeatability : ±1 %
Start-up time : 10 sec. after application of the operating voltage
Response : time 1..3 s
Pressure resistance Stainless steel compression fitting PN 40 bar
Plastic cone with union nut PN 10 bar
Medium temperature : -20..+ 70 °C -20..+100 °C (extended temperature range)
Ambient temperature : 0..+60 °C
Temperature dependency : ± 0.01 % / 1 K
Temperature gradient : 4 K/s
Materials medium-contact : Housing 1.4571
Materials nonmedium-contact : Plug PA6.6 gold-plated contacts
Supply voltage : 24 V DC ±10 % (controlled)
Power consumption : < 2 W
LED : yellow LED (On = Normal / Off = Alarm / rapid flashing = Programming)
Electrical connection : for round plug connector M12x1, 4-pole
Ingress protection : IP 67
Weight approx. : 0.05 kg
Our company is not an authorized distributor or representative for this brand. We are a reseller company for this brand.